Joined: Sun Oct 12 2008, 12:58AM
Location: independence mo.
Posts: 5
i was thinking on getting a pair of these headers for the fury and wanted to know if anybody here has used them,they dont say they are for a c body, but when i looked them up there, and a few other sites, including the headman site , these are the ones they say will fit. and i was wondering if for sure and how they fit and if there was any problems with them or how hard were they to install on the c body fury's http://www.summitracing.com/parts/hed-78030 any ideas guys?thanks
Joined: Fri Dec 21 2012, 09:24PM
Location: wellington , new zealand
Posts: 32
SOrry, i misread this thread and mistook it for one i had posted in, wrote a big reply, and realised it was not relevent, so i deleted it, and replaced it with this explanation as i could not fully delete the post <span class='smallblacktext'>[ Edited Tue Feb 19 2013, 12:48AM ]</span>
All I can say is the last set of Headers that I helped install was on a like year MoPar. It took about 45 minutes at the most to remove the old-with the use of a "Saws-All" or big hammers. The installation then took what seemed as several hours. There was even some "custom notching" on this new set of headers ( this is also stated by others here on this site ).
In the end - the driver ( Tom Bromley ) said that he had wasted his money for the total effect was not power effective unless he was above about 4,000 RPM's and he should have just modified The Exhaust System from The Exhaust Manifold Header Pipes to The Rear Bumper. His wife always says that if Tom did any of The Lastest Fuel Bills he would know her thoughts.
Joined: Wed Dec 21 2005, 07:34AM
Location: indiana
Posts: 791
As the question of headers comes up so often, I'll just say I love my Hedman shorties. Super-easy install. Probably not hte performance increase some other headers might give, but easier to install and lots cheaper too.