Joined: Wed Nov 17 2010, 03:28PM
Location: florida
Posts: 1311
i have a 66 3 spoke wheel and a 3 spoke full circle horn ring and nothing else.does anyone have pics of how they assemble and what other parts i need to mount it all together. i can post pics of what i got later if that helps my question.
I will scan and send the parts picture page later.
If I recall correctly, essentially the wheel bolts to the column with a cental nut. Then there is the horn switch, which is basically a 3 inch plastic and steel ring that is bolted to the wheel with three studs, each of which are insulated from the switch by rubber grommets. This horn switch is connected by a wire to the horn relay. There is also a brass spring which fits in there in a sort of groove in the switch. Lastly your full horn ring bolts to the switch. I think it is also isolated by grommets too... but I can't remember....but basically, pressing on the horn ring makes contact with the switch which grounds out the relay telling ut to send power to the horn.