Joined: Fri Aug 05 2011, 08:06PM
Location: Brisbane Australia
Posts: 132
hey all
have some coming in the post, need to know where to put them, can some one use some string and give me the 2 measurements for the red lines, mm would be nice but ill take what i can get I tried a search to see if the info was already up, but no luck I figured that point on the inside of the guard was the first bit unaffected by "manufacturing tolerances" that was good as a reference point as its part of the outside skin
Joined: Sat Mar 29 2008, 03:36PM
Location: North eastern Wis.
Posts: 1638
Unfortunately I scrapped the fenders I had with these lights, but there is a Mr. Richard Ehernberg of "Mopar Action" fame that seems to have a plethora of these types of diagrams. I believe he is also a member at the moparts site.
Joined: Fri Aug 05 2011, 08:06PM
Location: Brisbane Australia
Posts: 132
- bump -
Please, please, please, come on its summer over there, 2 minutes with a tape measure, you should be able to do it one handed and keep hold of that beer
sorry hate bumping posts, but i would like to attach the the damn things and need help. I got a nice reply from R Ehernberg, but unfortunately he has zero spec's for c bodies in that area
Hey there, I used painters tape to make the measurements, as you can see there is a little bit of a bend in the tape where it goes down off the fender but i don't think that will throw the measurement off too much. Anywho piece "A" is 201.6 mm and piece "B" is 165.1 mm both measured from arrow to arrow, right where you had the red lines. I hope this works for you! feel free to ask me for any other measurements if you need them.
From what I can see, that little dimple on the inner edge of the fender is lined up exactly where the rear-most hole is supposed to go... I'm sure by your response you're clear on the measurements shown in the pics, but I can't really decipher what he's measuring from....