Joined: Tue Jan 05 2010, 07:39PM
Location: Texas
Posts: 54
I currently have two 1966 Plymouth Fury's. One was just media blasted and primed. These cars need restoration. Please view the attached photo Galleries.
So the story goes: I purchased the Orange 1966 Fury III about 3 years ago and actually drove the car home from North Houston. I had plans to restore the car and disassembled the entire vehicle. The car went to be blasted and revealed lots of rust that was not repairable by someone like myself.
So then I found another car. 1966 Sport Fury all original with no motor. This car had been sitting North of Dallas in a field since 1989 when the motor was blown and pulled out. The metal on car is in great shape. Only showing surface rust and a few pin holes here and there. So anyway, I completely disassembled this car as well.
So at this point in time the Sport Fury is on a rotisserie in my garage. I have the other car and tons of other parts in a storage unit. I also picked up a running 1966 440 motor that I was going to use for this project. The Sport Fury Body was just Media Blasted and Primed. It is in great condition.
So right now I have to cars, 383 motor, 440 motor, two 727 tyranny's, two diffs, Rotisserie, and two or three of everything else.
I really just don't have time to ever finish this project so I figured I would list it all here. Check out the photos. This is all the pictures I took during the disassembly of both cars.
Joined: Fri Nov 04 2011, 11:55AM
Location: san jose, ca
Posts: 24
Hello, Merry Christmas! I too have a 66 Sport Fury, mine is a Convertible. In your pictures I see that there is a console with a Tach, correct? I need the "Tach and any wires, etc." to install in my car. I hope it's available? Let me know what can be done, please, call my cell 1-408-210-4736