Joined: Fri Oct 30 2009, 04:32PM
Location: Chelmsford MA
Posts: 174
68 Fury III, Stroked Small Block ok, I located a clutch pedal assembly I am in need of info on what to use for clutch rods and a z bar? anyone used anything different? Hydro setup? I am open to idea, just collecting parts right now I so far have a Aluminum Small Block Bell Housing And 4 Speed Manuel brake Pedals
Joined: Sun Jan 04 2009, 02:51AM
Location: Washington
Posts: 44
I have everything (pedals, brackets, spring, z-bar) from a '67 PB 4 speed car. I can take measurements and send pics if you need any. There are two support brackets that connect the firewall to the top of the drivers fender well, these are to support the stress of constant clutch pedal movement.
Joined: Sun Jan 04 2009, 02:51AM
Location: Washington
Posts: 44
I just re painted my pedal set yesterday and took these before and after pics. If you need pics or measurements of the other parts let me know and I'll do my best to get that for you.
Joined: Fri Oct 30 2009, 04:32PM
Location: Chelmsford MA
Posts: 174
awesome!!!! thank you very very much for the reference photos. if you can take pics of all the other stuff and measurments etc. that would be wonderful. what pivot balls are you using? etc. if you can get me some lengths of the linkage etc. that would be great than I can call brewers and maybe match up some stuff. also. what about the clutch adjuster down by the fork can I get a kit, like you can for a b / e body? etc.... thank you again very greatful