C-Body DryDockPhoto courtesy of Polara71
 
| Home | Search | Forum | Tech Articles | Links | Downloads | Members | FAQ |
Forums
C-Body DryDock :: Forums :: C-Body :: General Tech
 
<< Previous thread | Next thread >>
Line bore gone bad...
Moderators: NFURY8
Author Post
KiwiDan
Mon Apr 21 2014, 03:48AM
Registered Member #1448
Joined: Thu Mar 13 2008, 03:54PM
Location: Brisbane Aust
Posts: 26
 Hi all,

Well got my 451 block back from machinist and started to check it out.
It doesn't look right to me...there is a lip that your finger nail can catch
Has anyone had this happen before?
Whats the thoughts here, will it matter or should I return to the machinist.
Thanks in advance
Back to top
Website
Mrmopartech
Mon Apr 21 2014, 07:24PM
Registered Member #1030
Joined: Thu Jul 12 2007, 10:35PM
Location: St.lazare Quebec Canada
Posts: 262
 Block needs to be line hoed again,a Yeep job was done,mrmopartech
Back to top
BigBlockMopar
Wed Apr 23 2014, 04:58AM
Registered Member #18
Joined: Mon Oct 10 2005, 10:24AM
Location: The Netherlands
Posts: 160
 Did they use the correct caps on the correct mains during line honing?
I presume you got the correct one on the proper mainsaddle right?
Back to top
Website
KiwiDan
Wed Apr 23 2014, 05:19AM
Registered Member #1448
Joined: Thu Mar 13 2008, 03:54PM
Location: Brisbane Aust
Posts: 26
 The caps were not off this block, yes they are installed 1-5 front to back....all the hone lines line up....it looks like all the caps were in the correct location.
I'm going to take it back next week as I'm not comfortable assembling it as is...
Back to top
Website
Fury440
Wed Apr 23 2014, 09:54AM
Registered Member #73
Joined: Tue Oct 11 2005, 01:33AM
Location: Calgary, Alberta
Posts: 5893
 Doesn't look like the block has been tanked, a lot of crud in the pictures.
Back to top
Website
Alchemi
Sun Apr 27 2014, 06:28PM
Registered Member #3940
Joined: Fri Aug 05 2011, 08:06PM
Location: Brisbane Australia
Posts: 132
 Looks like it been done with a cylinder hone - the cross hatching

There's no way that could be considered line bored - have you checked the dimensions?

+1 on the hot tank - you don't want any rust near/in the bolt holes and bearing surfaces
Back to top
KiwiDan
Mon Apr 28 2014, 05:04PM
Registered Member #1448
Joined: Thu Mar 13 2008, 03:54PM
Location: Brisbane Aust
Posts: 26
 Block has been dropped back to machine shop....block is coated with grease hasn't been cleaned for assembly yet fellas.... Will advise the outcome.
Back to top
Website
 

Jump:     Back to top
All Rights Reserved 2006-2021.
Render time: 0.0510 sec, 0.0114 of that for queries. DB queries: 28.